Maintenant, beaucoup de professionnels IT prennent un même point de vue que le test Juniper JN0-532 est le tremplin à surmonter la pointe de l'Industrie IT. Beaucoup de professionnels IT mettent les yeux au test Certification Juniper JN0-532.
Le test de Certification Juniper JN0-532 devient de plus en plus chaud dans l'Industrie IT. En fait, ce test demande beaucoup de travaux pour passer. Généralement, les gens doivent travailler très dur pour réussir.
Pass4Test possède un l'outil de formation particulier à propos de test Juniper JN0-532. Vous pouvez améliorer les techniques et connaissances professionnelles en coûtant un peu d'argent à courte terme, et vous preuver la professionnalité dans le future proche. L'outil de formation Juniper JN0-532 offert par Pass4Test est recherché par les experts de Pass4Test en profitant les expériences et les connaissances riches.
Si vous vous inscriez le test Juniper JN0-532, vous devez choisir une bonne Q&A. Le test Juniper JN0-532 est un test Certification très important dans l'Industrie IT. C'est essentielle d'une bonne préparation avant le test.
Dans l'Industrie IT, le certificat IT peut vous permet d'une space plus grande de se promouvoir. Généralement, la promotion de l'entreprise repose sur ce que vous avec la certification. Le Certificat Juniper JN0-532 est bien autorisé. Avec le certificat Juniper JN0-532, vous aurez une meilleure carrière dans le future. Vous pouvez télécharger tout d'abord la partie gratuite de Q&A Juniper JN0-532.
Code d'Examen: JN0-532
Nom d'Examen: Juniper (FWV,Specialist (JNCIS -FWV))
Questions et réponses: 146 Q&As
Le guide d'étude de Pas4Test comprend l'outil de se former et même que le test de simulation très proche de test réel. Pass4Test vous permet de se forcer les connaissances professionnelles ciblées à l'examen Certification Juniper JN0-532. Il n'y a pas de soucis à réussir le test avec une haute note.
JN0-532 Démo gratuit à télécharger: http://www.pass4test.fr/JN0-532.html
NO.1 Click the Exhibit button.
In the exhibit, which two can be determined about the VPN? (Choose two.)
A.NAT-traversal is enabled.
B.The rekey interval is 8 hours.
C.This device initiated the Phase 1 negotiations.
D.The certificate used in this exchange is set to never expire.
Answer: BC
Juniper JN0-532 JN0-532 JN0-532 examen
NO.2 Which CLI command identifies the multicast sources visible to your ScreenOS device?
A.get route pim
B.get igmp source all
C.exec pim interface all query
D.get vrouter trust-vr protocol pim
Answer: D
Juniper JN0-532 JN0-532 examen JN0-532 certification JN0-532
NO.3 Review the exhibit.
Which two of the following elements must be configured on the ScreenOS device in order to support
PIM-SM? (Choose two)
A.A multicast control policy
B.A bootstrap router process
C.A unicast routing protocol
D.A static RP
Answer: AC
Juniper examen JN0-532 JN0-532
NO.4 You have configured the following on your device.
set address trust MyPC 10.1.1.5/32
set address untrust CorpNet 10.10.0.0/16
set policy from trust to untrust MyPC CorpNet any permit
set int tunnel.1 zone untrust
set int tunnel.1 ip unnumbered int bgroup1
set ike gateway GW address 1.1.1.1 outgoing-interface e0/1 preshare Secret sec-level standard
set vpn VPN gateway GW sec-level standard
The tunnel interface is down, so the VPN cannot function properly. What is the problem?
A.The policy needs to have the action tunnel.
B.The VPN needs to be bound to the tunnel interface.
C.The tunnel interface needs to be placed in the trust zone.
D.The tunnel interface needs to be associated with the interface in the untrust zone.
Answer: B
Juniper JN0-532 JN0-532 JN0-532 examen
NO.5 During main mode negations a failure has occurred while using IKE certificates.
Which message pair would you review to troubleshoot this failure?
A.messages 1 & 2
B.messages 2 & 3
C.messages 3 & 4
D.messages 5 & 6
Answer: D
Juniper JN0-532 JN0-532 certification JN0-532 JN0-532
NO.6 You have entered the command set ffilter src-ip 1.1.7.250 dst-ip 10.1.10.5 ip-prot 6
What will be the resulting output in the debug for which this was created?
A.If the packet has a src-ip of 1.1.7.250 or a dst-ip of 10.1.10.5 or has TCP as its protocol then it will be
captured
B.If the packet has a src-ip of 1.1.7.250 or a dst-ip of 10.1.10.5 or has UDP as its protocol then it will be
captured
C.If the packet has a src-ip of 1.1.7.250 and a dst-ip of 10.1.10.5 and has TCP as its protocol then it will
be captured
D.If the packet has a src-ip of 1.1.7.250 and a dst-ip of 10.1.10.5 and has UDP as its protocol then it will
be captured
Answer: C
Juniper examen JN0-532 JN0-532
NO.7 What must be enabled to protect Phase 2 key exchanges?
A.Phase 1 PFS
B.Phase 2 SHA
C.Phase 2 3-DES
D.Phase 2 DH key exchange tiations? (Choose two.)
A.proxy-id, SA proposal list
B.IKE cookie, SA proposal list
C.hash [ID + Key], DH key exchange
D.SA proposal list, optional DH key exchange
Answer: D
Juniper JN0-532 JN0-532 certification JN0-532
NO.8 Which ScreenOS CLI command is necessary for configuring IGMP on interface ethernet0/1?
A.set igmp interface ethernet0/1
B.set multicast interface ethernet0/1
C.set interface ethernet0/1 igmp router
D.set igmp interface ethernet0/1 enable
Answer: C
Juniper examen certification JN0-532 JN0-532 examen JN0-532
NO.9 Which three OSPF parameters are interface parameters? (Choose three.)
A.cost
B.priority
C.neighbor list
D.summarization
E.advertise default route
Answer: ABC
Juniper JN0-532 certification JN0-532
NO.10 Review the exhibit.
You've been asked to build a route-based hub and spoke network, with policy control for traffic travelling
from spoke to spoke. Which two of the following configuration options will meet this requirement?
(Choose two.)
A.Place the spoke tunnel interfaces in the trust zone and create policies on the spokes.
B.Place the spoke tunnel interfaces in the untrust zone and create policies on the spokes.
C.Create a single tunnel interface in the trust zone at the hub and enable intra-zone blocking.
D.Create separate tunnel interfaces at the hub and place them in different zones, then create policies at
the hub.
Answer: BD
certification Juniper JN0-532 certification JN0-532
NO.11 Click the Exhibit button.
Review the exhibit. Track-ip has failed on the device, but the device did not fail over to the second unit in
the cluster:
Why has failover not occurred?
A.The physical interfaces have not failed.
B.The track-ip interval is not sufficient to cause failover.
C.The track-ip address weight is not sufficient to cause failover.
D.The track-ip address threshold is not sufficient to cause failover.
Answer: C
Juniper examen JN0-532 JN0-532 JN0-532 examen
NO.12 Which command is used to verify that IGMP is running correctly?
A.get route igmp
B.get igmp query
C.set igmp query interface e0/1
D.exec igmp interface e0/1 query
Answer: D
Juniper JN0-532 JN0-532 examen certification JN0-532
NO.13 You have created a virtual router called VSYSA-vr and made it shareable. You then create the VSYS
using the WebUI, telling it to use an existing VR and selecting the VR called VSYSA-vr.
What is the status of the virtual router after you create the VSYS?
A.The router will be the default router but will no longer be shared.
B.The router will be the default router and will still have a shareable status.
C.The system will not let you use a shared virtual router when you create a new VSYS. The initial virtual
router must be private.
D.The system will not create a private vr for the VSYS but will assign the untrust-vr as the default router.
The shared Virtual router will not be the default router.
Answer: B
Juniper JN0-532 JN0-532 examen
NO.14 Which three statements are true regarding IKE Phase 1? (Choose three.)
A.Placing the SA proposal list in message 1 is an option.
B.The digital certificate is used to decrypt the session key.
C.The DH key exchange is used to validate the session key.
D.The DH key exchange and digital certificates are both optional.
E.The proxy-id is used to determine which SA is referenced for the VPN.
Answer: ABC
certification Juniper JN0-532 JN0-532 examen JN0-532
NO.15 Click the Exhibit button.
In the exhibit, what is the source IP address of the multicast traffic?
A.236.1.1.1
B.10.10.10.1
C.20.20.20.10
D.20.20.20.200
Answer: B
Juniper JN0-532 JN0-532 examen
NO.16 Click the Exhibit button.
In the exhibit, what is the address of the multicast receiver?
A.234.9.8.42
B.192.168.10.2
C.192.168.20.10
D.192.168.20.200
Answer: D
certification Juniper JN0-532 examen certification JN0-532 certification JN0-532 JN0-532
NO.17 What must be configured differently for a route-based VPN and a policy-based VPN?
A.proxy-id
B.proposals
C.remote gateway type
D.binding the tunnel interface
Answer: D
certification Juniper JN0-532 JN0-532
NO.18 Which two item pairs are exchanged during Phase 2 negotiations? (Choose two.)
A.proxy-id, SA proposal list
B.IKE cookie, SA proposal list
C.hash [ID + Key], DH key exchange
D.SA proposal list, optional DH key exchange
Answer: AD
Juniper JN0-532 examen certification JN0-532 JN0-532 JN0-532 JN0-532
NO.19 Click the Exhibit button.
In the exhibit, the firewall administrator at the Storefront is complaining that when the communication to
the DataCenter1 fails, the preexisting transfers and applications are dropped when the traffic is switched
to DataCenter2.
Which statement explains this behavior?
A.SYN checking is enabled in the tunnel.
B.The weight value for the DataCenter2 is too high.
C.VPN monitor is misconfigured in the DataCenter2.
D.Phase 1 and Phase 2 negotiations to DataCenter2 did not occur on time.
Answer: A
Juniper JN0-532 JN0-532 JN0-532 examen
NO.20 To which three ScreenOS components can a policy-based routing policy be bound? (Choose three.)
A.zone
B.policy
C.interface
D.virtual router
E.virtual system
Answer: ACD
Juniper examen JN0-532 JN0-532 examen JN0-532
Beaucoup de travailleurs espèrent obtenir quelques Certificat IT pour avoir une plus grande space de s'améliorer. Certains certificats peut vous aider à réaliser ce rêve. Le test Juniper JN0-532 est un certificat comme ça. Mais il est difficile à réussir. Il y a plusieurs façons pour se préparer, vous pouvez dépenser plein de temps et d'effort, ou vous pouvez choisir une bonne formation en Internet. Pass4Test est un bon fournisseur de l'outil formation de vous aider à atteindre votre but. Selons vos connaissances à propos de Pass4Test, vous allez faire un bon choix de votre formation.
没有评论:
发表评论